Instruction manual

TOOL INSTALLATION INSTRUCTIONS AND USE
Lubrication
To insure maximum performance, install the air set
(oiler, regulator, air filter) as close as possible to the
tool. Adjust the oiler
so that one drop of oil will be
provided for every
30 nails.
When the air
set oiler is not used, oil with a few drops
of turbine oil through the air plug both before and
after nailing operations. Simply
oil before use, but
when oiling after use, operate the tool several times
to assure good lubrication. This makes certain the oil
works into and throughout the tool to prevent rust-
ing. When using the tool for
a long time, oil during
nailing operations.
Loading nailer
CAUTION:
Always disconnect the air hose before loading the nails into the nailer
I
Pull the pusher until it is locked by the lock lever.
I
Pusher
I
Insert strip of nails into the magazine. Two strips of
nails can be loaded
at a time.
Make sure that when loading the second strip the first
nail of the second strip
sets on (overlaps) the last nail
of the first strip.