Instruction manual

There may be local regulations concerning noise
I
which must be complied with by keeping noise levels
within prescribed limits. In certain cases, shutters
should be used to contain noise.
Do not tamper with the tool or attempt to use it for
other than nailing.
Do not play with the contact arm;
it prevents accidental discharge, so it must be kept
on and not removed. Securing the trigger
in the ON
position is also very dangerous. Never attempt to
fasten the trigger.
Operate the tool within the specified air pressure of
4.2 - 8.5 kgf/cm’G (60 - 120 PSIG) for safety
and longer tool life. The tool should not be connected
to a source whose pressure potentially exceeds
14.0
kgf/cm’G (200 PSIG).
Shutter
Trigger
Contact arm
120 PS1.G 120 PSIG
Never use the tool with other than compressed air.
If high-pressure gas (propane, acetylene, oxygen,
etc.) is used as a Dower source for this tool, the tool