Specifications

6
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always lock the trigger and disconnect the hose before adjusting or
checking function on the tool.
Nose adapter
When nailing workpieces with easily-marred surfaces, use the nose adapter. It
is factory installed at the rear of the tool.
Attach the nose adapter to the contact arm. When not in use, store the nose
adapter at the rear of the tool to keep it from being lost.
Adjusting depth of nailing
To adjust the depth of nailing, turn the adjuster so that the arrow above the
adjuster will point to the number indicated on the adjuster. The depth of nailing
is the deepest when the arrow points to the number 1. It will become shallower
as the arrow points to higher number. The depth can be changed in approx.
1.0 mm increments per graduation. If nails cannot be driven deep enough
even when the arrow points to the number 1, increase the air pressure. If nails
are driven too deep even when the arrow points to the number 9, decrease the
air pressure. Generally speaking, the tool service life will be longer when the
tool is used with lower air pressure and the adjuster set to a lower number.
1. Nose piece storing portion
1
005462
1. Contact arm
2. Nose adapter
1
2
005463
1. Adjuster
1
005467