Operators Manual

11 ENGLISH
1
►1.Ejectedlinkedsheet
Removing jammed nails
CAUTION: Always lock the trigger by turning
the trigger lock lever to the lock position , and
disconnect the hose before removing jammed
nails. Also remove the nails from the magazine
before cleaning a jam.
1. Depress the latch lever and open the door. Open
the magazine cap and remove the nail coil.
2. Insertasmallmetalrodintothenailejectionport
and hit it with a hammer lightly.
1
2
3
►1. Metal rod 2.Nailejectionport3. Hammer
3. Removethejammednailwithaat-bladescrew-
driver or other similar tool.
4. Reset the nail coil and close the magazine cap
and the door.
MAINTENANCE
CAUTION: Before attempting to perform
inspection or maintenance, always lock the trig-
ger by turning the trigger lock lever to the lock
position , and disconnect the air hose from the
tool.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
1
►1. Magnet
Storage
Whennotinuse,disconnectthehose.Thencaptheair
ttingwiththecap.Storethenailerinawarmanddry
place.
1
►1.Cap
Maintenance of compressor, air set
and air hose
Afteroperation,alwaysdrainthecompressortankand
theairlter.Ifmoistureisallowedtoenterthetool,
it may result in poor performance and possible tool
failure.