Operators Manual

4 ENGLISH
8. Do not activate the tool unless the tool is
placed rmly against the workpiece.
9. Never hold or carry the tool with a nger on the
trigger or hand it to someone in this condition.
Accidentalringcancauseseriousinjury.
10. Never use fastener driving tools marked with
the symbol "Do not use on scaffoldings, lad-
ders" for specic application for example:
— when changing one driving location to
anotherinvolvestheuseofscaffoldings,
stairs,ladders,orladderalikeconstructions,
e.g. roof laths;
— closing boxes or crates;
— ttingtransportationsafetysystemse.g.on
vehicles and wagons.
11. Check walls, ceilings, oors, roong and
the like carefully to avoid possible electrical
shock, gas leakage, explosions, etc. caused by
striking live wires, conduits or gas pipes.
12. Do not use the tool for fastening electrical
cables. It is not designed for electric cable instal-
lation and may damage the insulation of electric
cablestherebycausingelectricshockorre
hazards.
13. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
whenworkinginhighlocations,andsecuretheair
hosetopreventdangerifthereissuddenjerking
or catching.
14. On rooftops and other high locations, drive
fasteners as you move forward. It is easy to lose
your footing if you drive fasteners while inching
backward. When driving fasteners against perpen-
dicularsurface,workfromthetoptothebottom.
You can perform driving operations with less
fatigue by doing so.
15. A fastener will be bent or the tool can become
jammed if you mistakenly drive fastener on
top of another fastener or strike a knot in the
wood. The fastener may be thrown and hit
someone, or the tool itself can react danger-
ously. Place the fasteners with care.
16. Do not leave the loaded tool or the air com-
pressor under pressure for a long time out in
the sun. Be sure that dust, sand, chips and
foreign matter will not enter the tool in the
place where you leave it setting.
17. Never attempt to drive fasteners from both the
inside and outside at the same time. Fasteners
mayripthroughand/oryoff,presentingagrave
danger.
Service
1. Perform cleaning and maintenance right after
nishing the job. Keep the tool in tip-top condi-
tion. Lubricate moving parts to prevent rusting and
minimize friction-related wear. Wipe off all dust
from the parts.
2. Ask Makita authorized service center for peri-
odical inspection of the tool.
3. To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed
by Makita Authorized Service Centers, always
using Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
PARTS DESCRIPTION
1
2
3
4
5
►1.Trigger2.Triggerlocklever3. Hook 4. Magazine
cap 5. Nose adapter (contact element)
INSTALLATION
Selecting compressor
0
0
10 20 30 40 50 60
20
40
60
80
100
120
140
1
2
3 4
5
1.Nailingfrequency(times/min)2.Compressorair
outputperminute(L/min)3. 2.26 MPa (22.6 bar) 4. 1.77
MPa (17.7 bar) 5. 1.28 MPa (12.8 bar)