Operators Manual

9 ENGLISH
— Make sure that the tool does not operate only by
placing the contact element against the workpiece
without pulling the trigger.
1
2
3
►1.Contactelement2. Workpiece 3.Trigger(not
pulled)
— Insinglesequentialactuationmode,makesure
that the tool does not operate when pulling the
triggerrstandthenplacingthecontactelement
against the workpiece.
1
2
Nailing method
Topreventthetriggerfrombeingaccidentallypulled,
the trigger lock lever is provided.
Tolockthetrigger,turnthetriggerlocklevertothelock
position
.
Tousethetool,turnthetriggerlocklevertotheunlock
position .
1
1
2
2
►1.Triggerlocklever2.Trigger
Single sequential actuation
Place the contact element against the workpiece and
pull the trigger fully.
Afternailing,releasethecontactelement,andthen
release the trigger.
1
2
CAUTION: Do not place the contact element
against the workpiece with excessive force. Also,
pull the trigger fully and hold it on for 1-2 seconds
after nailing.
Eveninthe“Singlesequentialactuation”mode,half-
pulledtriggercausesanunexpectednailing,whenthe
contact element re-contacts the workpiece.
Contact actuation
Pullthetriggerrstandthenplacethecontactelement
against the workpiece.
2
1