Use and Care Manual

5 ENGLISH
Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efcient nailing operation.
Lubrication
1
► 1. Pneumatic tool oil
Oil the tool with pneumatic tool oil by placing two or
three drops into the air tting. This should be done
before and after use.
For proper lubrication, the tool must be red a couple of
times after pneumatic tool oil is introduced.
FUNCTIONAL
DESCRIPTION
CAUTION: Before adjusting or checking func-
tion on the tool, always lock the trigger by turning
the trigger lock lever to the lock position
, and
disconnect the air hose from the tool.
Adjusting depth of nailing
This toll has the adjuster of the nailing depth. To mod-
ulate the nailing depth, turn the adjuster to the proper
depth.
1
► 1. Adjuster
The adjustable range is 8.5 mm (11/32"). (One full turn
allows 1.25 mm (1/16") adjustment.)
123
► 1. Too deep 2. Flush 3. Too shallow
Hook
CAUTION: Always disconnect the hose when
hanging the tool using the hook.
CAUTION: Never hook the tool at high loca-
tion or on potentially unstable surface.
CAUTION: Do not hang the hook from the
waist belt. If the nailer accidentally drops, it may
result in misring and personal injuries.
The hook is useful for hanging up the tool temporarily.
The hook can be turned while pushing the bottom to the
desired angle.
1
► 1. Hook
Furthermore, this hook can be installed on either side
of the tool.
To change the installation position, remove the bolt with
a hex wrench. Install the hook on another side and then
secure it rmly with the bolt.