ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Auto Feed Screwdriver BFR440 006800 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model BFR440 Screw strip 4 mm x 25 mm - 41 mm No load speed(min-1) 4,000 Overall length 357 mm Net weight 1.7 kg Rated voltage D.C.14.4 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country. • Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Uncertainty (K) : 1.
8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 9. If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. Use of an GFCI reduces the risk of electric shock. Personal safety 10. Stay alert, watch what you are doing and use common sense when operating a power tool.
GEB050-2 accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 21. Maintain power tools.
(3) 6. 7. 8. 9. Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. Do not use a damaged battery.
Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. Then pull the trigger switch again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the trigger switch again. Low battery voltage: The remaining battery capacity is too low and the tool will not operate.
ASSEMBLY • 1. Driving position 1 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing the bit Loosen the thumb screws which secure the casing. Pull out the casing in the direction of the arrow. 006805 Insert the screw strip through the screw guide. Then insert it through the feeder box until the first screw reaches the position next to the driving position. 1. Casing 2.
on the bit. This may also lead to poor fastening of screws and malfunction of the tool. OPERATION Driving operation MAINTENANCE • • Replacing carbon brushes 006811 Switch on the tool by pulling the switch trigger. Hold the tool squarely and firmly up against the driving surface. A screw will be automatically carried to the driving position and fastened.
1 • 1. Spring 2. Arm 3. Recessed part • NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. 3 2 006816 Use pliers to remove the carbon brush caps of the carbon brushes. Take out the worn carbon brushes, insert the new ones and replace the carbon brush caps in reverse. 1. Carbon brush cap 1 006817 Make sure that the carbon brush caps have fit into the holes in brush holders securely.
Makita Corporation Anjo, Aichi, Japan 884642C222 12 www.makita.
