Instructions / Assembly

２）Reassembly
（１）Run the STARTER ROPE through the
STARTER KNOB and make an overhand
knot as showin in Fig.6-3. Run
the STARTER KNOB at its opposite
side from the STARTER CASE to the
REEL, make a knot in the same way,
and put the ROPE end completely
in the ROPE HOUSING of the REEL.
Then, apply a small amount of
grease over the STARTER SHAFT
and SPIRAL SPRING
.
（２）Make sure that the SPIRAL SPRING
is fit completely in the spring
groove of the REEL. Form the SPRING Fig.6-3
end to have 1 to 2 mm clearance
between the SPIRAL SPRING inner
end and REEL BUSH so that the
STARTER SHAFT can hook on the HOOK
securely as shown in Fig.6-4.
The SPIRAL SPRING inner portion
(about 10cm-long from the end)
can be charged in shape.
（３）Before inserting the REEL in the
STARTER CASE, wind the STARTER
ROPE around the REEL three turns
in the direction of the arrow shown
in Fig.6-5, draw out the third turn
of the STARTER ROPE from the REEL
ct-out, and fit the REEL completely
inside the STARTER CASE so that
the SPIRAL SPRING inner end can hook
on the hook. then, hold the
Fig.6-4
STARTER ROPE as shown in Fig.6-5,
and twist the REEL 4 to 5 turns
in the direction of the arrow using
the REEL cut-out. After the completion
of winding, of the STARTER ROPE
hold the REEL tightly to prevent
the STARTER ROPE from winding back,
pull the STARTER KNOB in order for
the SPIRAL ROPE to tighten and then
release the STARTER KNOB slowly.
Reassemble the parts in r
everse
order of disassembly shown in
Fig.6-2. Tighten the SETSCREW
firmly.
Fig.6-5
29
SPIRAL SPRING END
REEL
SPIRAL SPRING INNER END
HOOK
STARTER SHAFT
※）Be sure to perform the following
procedure in order to make sure
that the parts have been fit
completely.