MSDS
3
SECTION 8. EXPOSURE CONTROLS AND PERSONAL PROTECTION:
Acceptable concentration:
Not specified in ACGIH.
Facilities:
Provide appropriate ventilation such as local ventilation system in the storage.
Protective clothing:
Gas mask for organic gases, safety goggle, safety glove.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES:
Appearance:
Lithium Ion Rechargeable Cells.
Average Operating Voltage:
3.60 V
SECTION 10. STABILITY AND REACTIVITY:
External short-circuit, deformation by crush, high temperature (over 100°C) exposure of a battery cause generation of heat and ignition.
SECTION 11. TOXICOLOGICAL INFORMATION:
Acute toxicity:
No information as a battery
Local effects:
No information as a battery
SECTION 12. ECOLOGICAL INFORMATION:
When exhausted battery is buried in the ground, corrosion may be caused on the outer case of battery and electrolyte may be oozed.
There is no information on environmental influence.
SECTION 13. DISPOSAL CONSIDERATIONS:
When battery is disposed, isolate positive (+) and negative (-) terminals of the battery to avoid those terminals from touching each other.
Batteries may be short-circuited when piled up or mixed with the other batteries in disorder. Dispose in accordance with applicable
federal, state and local regulations.
SECTION 14. TRANSPORT INFORMATION:
• The cells in these batteries have been tested and meet the requirements for the UN Manual of Tests and Criteria, Part III, subsection
38.3
• When a number of batteries are transported by ship, vehicle and railroad avoid high temperature and dew condensation.
• Avoid transportation which may cause damage of package.
• Lithium-ion batteries are not subject to dangerous goods regulation for the purpose of transportation by the International Maritime
Dangerous Goods regulations (IMDG). For Lithium-ion batteries, the Watt-hour rating is no more than 20Wh /cell and 100Wh/
battery pack can be treated as "non-dangerous goods" by the United Nations Recommendations on the Transport of Dangerous
Goods/Special Provision 188, provided that the products are prevented from being short-circuited with each other and are packaged in
an appropriate condition which satisfies Packing Group II performance level.