Finishing Sander MODEL BO4530 INSTRUCTION MANUAL DOUBLE UINSULATION S PEClFICAT IONS Dimensions 148 mm (6") 1 (L x W x H) 12,000 1 1 1 5 mm x 148 mm x 126 mm (4-112'' x 6" x 5") * Manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country t o country. 1 1 Net weight 1.1 kg (2.
IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PERSONAL INJURY, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS. 1. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. 2. CONSIDER WORK AREA ENVIRONMENT. Don't use power tools in damp or wet locations. Keep work area well lit. Don't expose power tools t o rain.
14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15. AVOID UNINTENTIONALSTARTING. Don't carry tool with finger on switch. Be sure switch is OFF when plugging in. 16. EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough t o carry the current your product will draw.
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle. outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that specified for the tool can result in SERIOUS INJURY t o the user - as well as damage to the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage less than the nameplate rating is harmful t o the motor. SAVE THESE INSTRUCTIONS.
HOW TO USE Attaching sandpaper *To attach the pressure-sensitivesandpaper, first peel off the paper covering the adhesive surface then apply the disc to the pad, being careful to align the edges. Fig. 2 Fig. 1 Switch action *Slide thumb switch left or right for starting or stopping. See ’‘ON’’-”OF F“ indication on sander body. I Switch Fig. 3 A sander is generally used to remove only a small amount of material a t a time.
MAINTENANCE Replacing carbon brushes .Take the tool t o an authorized Makita Service Center or Makita Branch Office when the carbon brushes must be changed. ACCESSORIES CAUTION: The accessories specified in this manual are recommended for use with your Makita Finishing Sander. The use of any other accessories might be hazardous. Rubber pad 0 Size 123 mm (5”) Diameter 148 mm (6”) Diameter ,110 mm x 100 mm (4-3/8”) x (4”) 0 1 I I Part NO.
FINISHING SANDER Model BO4530 Note: The switch, noise suppressor and other part configurations may differ from country to country.
MACHINE 1 11 Brush Holder 17 1 F Warher 6 Carbon Brush Ball Bearing 6 2 7 L L B A R M A T U R E ASSEMBLY IArrembled Items 3 & 41 18 1 Ball Bearing 19 1 Swirch 20 1 Noire Supprerror 21 1 Card Guard 5 1 Housing Set 22 1 6 1 CORD ASSEMBLY IArrembled Cord.