Instruction Manual

7 ENGLISH

3. Remove 2 caps from both ends of the pipe.

► 1. Pipe 2. Cap

NOTICE: Do not dispose of the caps since the

cap is necessary for storing the attachment.

4. Attach the protector and the sleeve to the pipe.

► 1. Pin 2. Pipe 3. Protector 4. Sleeve

NOTICE: Be sure to insert the end of the pipe

without the pin into the protector and the sleeve.

5. Make sure that the gear case and the pin on the

pipe are facing up, and then insert the pipe into the gear

case.

► 1. Gear case 2. Pipe 3. Pin

NOTICE: Make sure that the gear case and the

pin on the pipe are facing up, and the protector is

attached in the direction shown in the gure.

12 3

► 1. Gear case 2. Protector 3. Pin

6. Align the screw hole on the pipe with the hole on

the gear case by rotating the pipe.

► 1. Hole 2. Pipe