Instruction manual

5
ENGLISH (Original instructions)
Explanation of general view
SPECIFICATIONS
* NOTE: For continuous operation, high capacity battery cartridge BL1430 and BL1830 is recommended.
•Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
•Specifications and battery cartridge may differ from country to country.
•Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
END221-2
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
... Read instruction manual.
... Wear safety glasses.
Intended use
ENE080-1
The tool is intended for sawing and cutting wood, plastic,
gypsum, non-ferrous metals, and fastening elements (e.
g. unhardened nails and staples). It is also intended for
working soft wall tiles, as well as dry sanding and scraping
of small surfaces. It is especially for working close to edge
and flush cutting.
General Power Tool Safety
Warnings GEA006-2
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
1. Button
2. Red indicator
3. Battery cartridge
4. Star marking
5. Slide switch
6. Dial
7. Front lamp
8. Indication lamp
9. Application tool installation bolt
10. Holes in the application tool
11. Protrusions of the tool flange
12. Hex wrench
13. Tighten
14. Adapter (required for some
application tools)
15. Nozzle band
16. Dust nozzle
17. Dust attachment
18. Felt ring
19. Pad
20. Holes in the tool
21. Protrusions on the nozzle band
Model BTM40 BTM50
Oscillation per minute 6,000 - 20,000 (min
-1
)
Oscillation angle, left/right 1.6° (3.2° total)
Overall length 324 mm
Standard battery cartridge BL1430 BL1415 * BL1830 BL1815 *
Net weight
without dust extraction
attachment
1.9 kg 1.7 kg 2.0 kg 1.8 kg
with dust extraction
attachment
2.0 kg 1.8 kg 2.1 kg 1.9 kg
Rated voltage D.C. 14.4 V D.C. 18 V