Specifications

-15-
Lead wire (black)
Lead wire (brown)
Controller [46] (front)
Terminal support
Terminal support LD terminal
Lead wire (white)
Lead wire (brown)
Lead wire (red))
Switch (+) terminal
DC-Speed Control Switch [45]
Switch (-) terminal
Lead wire (white)
Controller [46] (front)
Terminal support (-) terminal
Terminal support (+) terminal
Brush Block [30]
FET
LED light
Flag terminal
Machine Screw
(W/Sp. Washer) M3 x 5 [41]
Lead wire (white)
Lead wire (brown)
Terminal support
Capacitor
Controller [46]
Lead wire (red)
DC-Speed Control Switch [45]
Lead wire (red)
Lead wire (black)
Fig. 4 • Switch-related reassembly (1)
Connection diagram (a)
Connection diagram (b)
Conduct reassembly by reversing the disassembly procedures, but note the following:
1. Switch-related reassembly
(1) Connect wires of the Controller [46] or DC-Speed Control Switch [45] according to the connection diagram
(Fig. 4) when replacing these units individually. Item (1) is omitted when replacing the Switch Ass'y [47].
• Solder the red and white lead wires extending from the upper part of the Controller [46] to the DC-
Speed Control Switch [45]. Connect the red lead wire to the "+" terminal of the DC-Speed Control
Switch [45] and the white lead wire to the "-" terminal. (See Fig. 4 (a).)
• Solder the black and white lead wires extending from the lower part of the Controller [46] to terminals
of the terminal support. Connect the black lead wire to the "-" terminal of the terminal support and the
white lead wire to the LD terminal. (See Fig. 4 (b).)
Reassembly