Specifications

-22-
J-295 jig (A)
for retaining ring
Retaining Ring [1]
Retainer [2]
J-295 jig (B)
for retaining ring
Push down.
Fig. 15 • Mounting Guide Sleeve (A)
4. Reassembling Housing (A).(B)Set
Insert Lock Nut M4 (Black) [43] and Packing [44] into Housing (A).(B)Set [39] as shown in Fig.14, and then
insert the Strap (Black) [48] into the boss of Fig.14. Next, assemble Housing (B) and tighten the nine
Tapping Screws (W/Flange) D4 x 20 (Black) [33].
5. Remounting Front Cover and Front Cap
Fit the Front Cover [6] and Front Cap [5] to the assembled housing. Make sure the PCB of the LED light is
in the LED holder, and fit the jut of the LED holder to the jut of the Hammer Case [7].
After setting the Front Cover [6], mount the Front Cap [5] and secure the Front Cover [6].
6. Mounting Guide Sleeve (A)
Insert the two Steel Balls D3.175 [12] into the main
shaft hole of the Pulse Unit [13], reassemble Guide
Sleeve (A) [4], Guide Spring [3], and Retainer [2] in
this order, and then fit the Retaining Ring [1] to the
main shaft groove of the Pulse Unit [13].
NOTE:
• Orient the shoulder portion of the Retainer [2]
towards the bit at assembly.
• The Retaining Ring [1] may be deformed when
disassembled and Guide Sleeve (A) [4] may
fall. Be sure to replace the Retaining Ring [1]
with a new one.
7. Mounting the Hook
Insert the Hook [37] into the groove in the lower portion of the side surface of Housing (A),(B), and then
tighten Truss Hd. Screw M4 (Black) [38] to secure it. Do not tighten Truss Hd. Screw M4 (Black) [38] too
quickly. Doing so may result in Lock Nut M4 (Black) [43] becoming idle in the housing and possibly sliding
off. To prevent this situation, slowly turn Truss Hd. Screw M4 (Black) [38] so as to engage Lock Nut M4
(Black) [43].
The Hook [37] can be mounted on any side (left or right) of the Pulse Driver