User Manual

11 ENGLISH
5. Push the rod gently until the piston touches the
package.
Toremovethepackage,removetheholdercap,nozzle,
rubber ring, and then push the rod handle forward until
it stops.
Direct lling
NOTICE: Make sure that 600 ml size holder
is attached to the holder joint and piston C is
attached to the rod. Do not use other type of
holder and piston for direct lling.
1. Remove the holder cap, nozzle, and rubber ring
from the holder.
►Fig.27: 1. Holder cap 2. Nozzle 3. Rubber ring
4. Holder
2. Push the rod handle all the way until it stops.
3. Insertthetipoftheholderintothecaulkingmate-
rial,andthenpulltherodhandleslowlytolltheholder
with the caulking material.
►Fig.28: 1. Holder
4. Attach the rubber ring, nozzle, and holder cap by
turningtheholdercaprmly.
►Fig.29: 1. Holder cap 2. Nozzle 3. Rubber ring
4. Holder
Caulking operation
Pull the trigger to feed the caulking material. Put one
hand under the holder to support the tool while operat-
ing it.
After the operation, wipe off the caulking material from
the tool. Be sure to remove the caulking material before
it becomes solid.
NOTE: At the beginning of operation, set the speed
adjustingdialto"1"andpulltheswitchtriggerslowly
to check how much amount of caulking material is
fed.
NOTE: Depending on the type and conditions of
caulkingmaterial,itmaynotbefedatlowspeed.In
thiscase,setthespeedadjustingdialhigher.
NOTE:Ifthecaulkingmaterialisnotfed,checkthe
following points:
• Thetipofcartridgenozzleisnotcutadequately.
• Thecaulkingmaterialissolidandcloggedinthe
nozzle.
• Thecartridgeorpackageisdamaged.
• Thecaulkingmaterialisstiff.Warmthematerial
until it becomes soft.
• Theattachedpistonisnotappropriateforthe
type of caulking material.
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
TomaintainproductSAFETYandRELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION: These accessories or attachments
are recommended for use with your Makita tool
specied in this manual.Theuseofanyother
accessories or attachments might present a risk of
injurytopersons.Onlyuseaccessoryorattachment
for its stated purpose.
Ifyouneedanyassistanceformoredetailsregard-
ing these accessories, ask your local Makita Service
Center.
• PistonA
• PistonB
• PistonC
• PistonD
• PistonE
• 300mlsizeholderset
• 600mlsizeholderset
• 800mlsizeholderset
• Nozzle(for600mlsizeholder)
• Nozzle(for800mlsizeholder)
• Safetygoggles
• Makitagenuinebatteryandcharger
NOTE: Some items in the list may be included in the
toolpackageasstandardaccessories.Theymay
differ from country to country.