ENGLISH (Original instructions) INSTRUCTION MANUAL Angle Drill DA3010 DA3010F DA3011 DA3011F 003794 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH (Original instructions) SPECIFICATIONS Model DA3010 DA3010F DA3011 Steel 10 mm 10 mm 10 mm 10 mm Wood 25 mm 25 mm 25 mm 25 mm No load speed (min-1) 0 -2,400 0 -2,400 0 -2,400 0 -2,400 Overall length 270 mm 270 mm 270 mm 270 mm Net weight 1.6 kg 1.6 kg 1.6 kg 1.6 kg Capacities Safety class DA3011F /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 19. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 20.
Installing side grip (handle) Reversing switch action 1 1. Reversing switch lever 1 A B 003796 003797 CAUTION: • Always check the rotational direction before operation. • Use the reversing switch only after the tool comes to a complete stop. It will damage the tool to change the rotational direction before the tool stops. This tool has a reversing switch to change the rotational direction.
MAINTENANCE OPERATION Holding the tool 1 CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. 1.
Makita Corporation Anjo, Aichi, Japan 884467G224 8