ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Angle Drill DA330D DA331D 013258 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model DA330D Capacities DA331D Steel 10 mm 10 mm Wood 12 mm 12 mm No load speed (min-1) 0 - 800 0 - 800 Overall length 298 mm 310 mm Net weight 1.1 kg 1.1 kg Rated voltage D.C. 10.8 V D.C. 10.8 V • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country.
6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
Service 28. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 29. Follow instruction for lubricating and changing accessories. 30. Keep handles dry, clean and free from oil and grease. Power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18.
ENC009-1 FUNCTIONAL DESCRIPTION IMPORTANT SAFETY INSTRUCTIONS • FOR BATTERY CARTRIDGE 1. 2. 3. 4. 5. 6. 7. 8. 9. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. Do not disassemble battery cartridge. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.
For model DA331D Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. Low battery voltage: The remaining battery capacity is too low and the tool will not operate. If you pull the switch trigger, the motor runs again but stops soon. In this situation, remove and recharge the battery.
Chuck key holder ASSEMBLY • For model DA330D CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 2 1 Installing or removing drill bit 1. Chuck key holder 2. Hook portion 3. Slot 4. Rail For model DA330D 3 1. Chuck key 1 4 013256 To install the chuck key holder, point the hook portion of it toward the housing.
• • • • • NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. CAUTION: Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. There is a tremendous force exerted on the tool/bit at the time of hole break through.
Makita Corporation Anjo, Aichi, Japan 885179-222 12 www.makita.
