Instructions
14 ENGLISH
4.
clockwise using the box wrench.
Fig.23: 1.2.3. Box
wrench
Make sure that all the guides on the internal circle of the
a rail which does not support the guide, the V-belt is not
Fig.24: 1.2. Guide on the V-belt
5. Place the cover onto the tool and tighten the hex
socket bolts using the hex wrench.
Fig.25: 1. Tube 2. Cover 3. Hex socket bolt
NOTICE: Make sure that the tube for water feed
attaching the cover.
TROUBLESHOOTING
-
ment parts for repairs.
State of abnormality Probable cause (malfunction) Remedy
Motor does not run.
Motor stops running after a little use.
Overheating. Stop using of tool to allow it to cool down.
The wheel rotation does not acceler-
tool without load for 20 seconds.
manual.
The V-belt is slipping. Replace the V-belt with new one.
The V-belt is slipping. Replace the V-belt with new one.
guard and the wheel.
Improper attachment of the wheel. Install the wheel as instructed in this manual.
Electric or electronic malfunction.
Poor cutting performance It is time to replace the wheel. Replace the wheel with new one.
Water leaks from the inlet. Water is leaking from the O-ring part.