Instructions
11 ENGLISH
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
Fig.3: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps Remaining
capacity
Lighted Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
from the actual capacity.
Switch action
Fig.4: 1. ON/speed change button 2. OFF button
To start the cleaner, simply push the ON/speed change
You can change the cleaner speed in three steps by
pushing the ON/speed change button.
second push for max speed mode and the third push for
normal speed mode. Each push on this button repeats
the high/max/normal speed cycle alternatively.
Lighting up the lamp
CAUTION: Do not look in the light or see the
source of light directly.
To turn on the lamp, push the ON/speed change button.
tool actuating, the lamp turns on.
When the remaining battery capacity gets low, the lamp
starts blinking.
Fig.5: 1. ON/speed change button 2. OFF button
3. Lamp
NOTE: The timing, at which the lamp starts blinking,
depends on the temperature at work place and the
battery cartridge conditions.
ASSEMBLY
CAUTION: Always be sure that the tool is
before carrying out any work on the tool.
Parts description
Optional accessory
Fig.6: 1. Capsule 2.3. Stay
Fig.7: 1. Capsule 2.3. High performance
4.
NOTICE:
The high perfor-
NOTE:
at the same time, the suction power may be reduced.
NOTE:
-
Fig.8: 1. Stay
Disposing of dust
CAUTION: Empty the cleaner before it
becomes too full, or the suction force weakens.
CAUTION: Be sure to empty the inside of the
cleaner itself of dust. Failure to do so may cause the
tap the capsule 4 or 5 times with your hand.
Fig.9: 1. Capsule 2. Suction inlet
Point suction inlet downwards, turn capsule in direction of
arrow in diagram, and disconnect capsule slowly and straight.
Fig.10: 1. Capsule 2. Suction inlet
NOTE: Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
Remove accumulated dust from the inside of capsule
Fig.11: 1. Capsule 2.
-
Fig.12: 1. Securing lip
NOTE:-
cedure above.