Technical data

17
Approved bar and chain combinations
"Low-kickback saw chain is a chain which has met the
kickback performance requirements of ANSI B 175.1-
1991 (American National Standard for Power Tools-
Gasoline-Powered Chain Saws-Safety Requirements)
when tested on the representative sample of chain
saws below 3.8. C.l.D. specifed in ANSI B 175.1-
1991". The approved bar and chain combinations are
low kickback chains according to ANSI B 175.1-1991
and also meet the kickback requirements of CSA
Z62.3-96 for chain saws below 80 cm
3
.
The chain saw DCS 34 has been approved with
following guide bar and chain combinations:
Drive link gauge .050"
Guide bar 3/8" Saw chain 3/8"
length Part no. Part no.
14" (35 cm) 442 035 661 528 092 652
16" (40 cm) 442 040 661 528 092 656
"There may be other replacement bar and chain combi-
nations available that also reduces the risk of injury
from kickback".
Technical data DCS 34
Single-cylinder two-stroke
Piston displacement 2.0 cu. in (33 cm
3
)
Cylinder bore 1.45" (37 mm)
Piston stroke 1.22" (31 mm)
Max. power at speed 1.3/9,000 kW/rpm
Max. torque at speed 1.7/6,500 Nm/rpm
Idling speed 2,800 rpm
Sound Pressure Level at the operator’s ear
at full load according to ANSI B 175.1 98 db(A)
Sound Pressure Level at the bystander’s position
(50ft/15 m distance) according to ANSI B 175.1 73 db(A)
Ignition system
Electronic, without breaker
Spark plug NGK BPMR 7A
or Spark plug
Electrode gap .020" (0.5 mm)
Fuel system
Carburetor (for Canada) ZAMA
Carburetor (for USA) ZAMA with limiter caps
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity 13.0 oz. (0.37 l)
Fuel mixture see chapter "Fuel"
Weight
without cutting attachment 10 lbs. 5 oz. (4.7 kg)
Cutting attachment
Guide bar sprocket nose bar
Cutting length 14" (35 cm) • 16" (40 cm)
Safety saw chain (pitch) 3/8" (528 092 ...)
Drive link gauge .050"
Chain sprocket 6 teeth
Chain lubrication fully automatic oil pump
Oil tank capacity 8.8 oz. (0.25 l)
WARNING
Do not use other replacement bars and chains
unless they have been designated as meeting the
ANSI B 175.1-1991 (for USA) and CSA Z62.3-96
(for Canada) kickback performance requirements
on that specific powerhead, or has been desig-
nated as "low kickback" saw chain in accordance
with the ANSI B 175.1-1991 (for USA) and CSA
Z62.3-96 (for Canada) standard.