Instruction manual

CAUTION: Before doing any work on the guide bar or chain,

always switch off the engine and pull the plug

cap off the spark plug (see "Replacing the spark

plug"). Always wear protective gloves!

CAUTION: Start the chain saw only after having assembled

it completely and inspected.

PUTTING INTO OPERATION

- Always release the chain brake before removing or replacing

the sprocket guard (B/4). To do so, pull the hand guard (A/1)

towards the tubular handle (A/2) until you feel it catch.

C D

- Position the guide bar (D/8). Make sure that the pin (D/9)

of the chain tightener is in the hole (circled) on the guide

bar.

- Turn the chain adjusting screw (C/6) to the left (counter-

clockwise) until the pin (C/7) is at the left stop.

10 8

- Lift the chain (E/10) over the clutch drum and onto the

sprocket (E/11). Using your right hand, guide the chain into

the top guide groove on the guide bar (E/8). Note that the

cutting edges along the top of the chain must point in the

direction of the arrow!

- Lead the chain (F/10) around the sprocket nose (F/12) of

the guide bar.

NOTE: The chain should be easy to pull in the direction of the

arrow. The clutch drum (E/11) should turn with the chain (the

sprocket engages the chain).

Mounting the guide bar and saw chain

Use the universal wrench delivered with the chain saw for the

following work.

Put the chain saw on a stable surface and carry out the following

steps for mounting the guide bar and saw chain:

- Unscrew retaining nuts (B/3).

- Pull off the sprocket guard (B/4).

- Remove the plastic transport cover (B/5) and dispose of

properly.