User Manual

9 ENGLISH
PARTS DESCRIPTION
►Fig.1
1 Control panel 2 Battery cover 3 Upper cover hook
4 Upper cover 5 Handle 6 Carrying Handle
7 Opener 8 Filter cover 9 Wheel
10 “DC IN” socket 11 Temperature plus button 12 Power button
13 Cool / heat switch button 14 Temperature display 15 Battery indicator
16 Temperature reduction button - - - -
OPERATION
1. Connecting the power supply
A) Battery
CAUTION: Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery car-
tridge rmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridgermlymaycausethemtoslipoffyourhands
and result in damage to the tool and battery cartridge
andapersonalinjury.
To install the battery cartridge, open the battery
cover.
Align the tongue on the battery cartridge with the
groove in the housing and slip it into place. Insert it
all the way until it locks in place with a little click.
Then close the battery cover.
To remove the battery cartridge, slide it from the
appliance while sliding the button on the front of
the cartridge.
►Fig.2
►1. Red indicator 2. Button 3. Battery cartridge
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not
itmayaccidentallyfalloutofthetoolcausinginjuryto
you or someone around you.
CAUTION: Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: Up to two battery cartridges can be installed,
although the appliance uses one battery cartridge for
operation.
B) AC adaptor (Only use for
Recreational vehicle)
When using the appliance with AC power, use the AC
adaptor supplied with the appliance. Insert the plug to
“DC IN” inlet of the appliance and then insert the other
end to an outlet.
C) Cigarette lighter adaptor
When using the appliance with the cigarette lighter
socket, use the cigarette lighter adaptor supplied with
the appliance. Insert the plug to “DC IN” inlet of the
appliance and then insert the other end to the cigarette
lighter socket.
CAUTION: Insert the plug completely into the
“DC IN” inlet. Failure to do so may deform the plug
orcauseare.
CAUTION: Always close the “DC IN” socket
cover rmly when the power cord is not plugged.
NOTE: When the appliance shifts power supply, the
compressor will stop for about 3 minutes to protect the
compressor.
NOTE: After turning off the appliance, it takes about 3
minutes to restart the compressor because of the pro-
tection of the compressor.
2. Turning on the appliance
Press the power button to turn on the appliance. Press
the power button again to turn off the appliance.
3. Switching cooling / heating mode
Press the cool / heat switch button to switch the oper-
ating mode.
Thetemperaturedisplayashesthecontrol
temperature.
• When the appliance operates in cooling mode, the
control temperature is -18°C, -10°C, 0°C, 5°C or
10°C (0°F, 15°F, 30°F, 40°F or 50°F).
• When the appliance operates in heating mode,
the control temperature is 55°C or 60°C (130°F or
140°F).
4. Selecting the control temperature
Press the temperature plus button or the temperature
reduction button to select the control temperature.
The appliance starts cooling / heating 5 seconds after
without any operation, then the control temperature stop
ashingandthetemperaturedisplayshowsthecurrent
temperature.
The appliance stops cooling / heating when the current
temperature reaches the control temperature.