ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Driver Drill DF330D 009329 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH (Original instructions) SPECIFICATIONS Model Capacities -1 No load speed (min ) DF330D Steel 10 mm Wood 21 mm Wood screw 5.1 mm x 63 mm Machine screw M6 High (2) 0 - 1,300 Low (1) 0 - 350 Chuck capacity 0.8 mm - 10 mm Overall length 189 mm Net weight 1.0 kg Rated voltage D.C. 10.8 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
electric shock if your body is earthed or grounded. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use.
Service 28. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 29. Follow instruction for lubricating and changing accessories. 30. Keep handles dry, clean and free from oil and grease. Power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18.
ENC007-4 FUNCTIONAL DESCRIPTION IMPORTANT SAFETY INSTRUCTIONS • FOR BATTERY CARTRIDGE 1. 2. 3. 4. 5. 6. 7. 8. 9. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. Do not disassemble battery cartridge. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.
Speed change Turning on the front lamp 1. Lamp 1 1. Speed change lever 1 008803 009332 To change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or "1" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. CAUTION: • Do not look in the light or see the source of the light directly. Pull the switch trigger to turn on the light.
ASSEMBLY • • CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. CAUTION: Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. NOTE: • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. See the chart. Installing or removing driver bit or drill bit 1.
• If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. Using the tool as a hand screwdriver 008808 Two bits can be retained at the front of holster. 009335 Switch off the tool. Move the lock button to the locked position A. Turn the tool. NOTE: • This use is convenient for checking the screwdriving.
Makita Corporation Anjo, Aichi, Japan 884867B228 12
