Parts List

Fig. D-5
Test for recognizing the trouble on Stator complete
(1) Set Digital tester (1R402) in the diode mode ( mark on the tester: Refer to Fig. D-5.)
(2) Remove Battery, and then turn on Switch. (Fig. D-6)
(3) Attach Black tester bar to Plus terminal of Battery terminal.
Attach Red tester bar to Minus terminal of Battery terminal. (Fig. D-7.)
Note: Be careful not to revere them. The reverse attachment could spoil the test.
(4) Wait until the Tester shows the value without fluctuation. There is no fault on Stator complete if the tester indicates
within 0.8V plus/minus 0.1V.
If Tester indicates 0V or 0.4V approximately, Stator complete is out of order.
Replace Stator complete with new one.
P 14/ 14
Trouble shooting
Fig. D-6
Switch knob: lock-on position
Fig. D-6
Battery terminal