User Manual

8 ENGLISH
Lighting up the front lamp
1
►1. Lamp
CAUTION: Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
Thelampgoesoutapproximately10secondsafter
releasing the switch trigger.
NOTE:Useadryclothtowipethedirtoffthelensof
the lamp. Be careful not to scratch the lens of lamp, or
itmaylowertheillumination.
Electronic function
Thetoolisequippedwiththeelectronicfunctionsfor
easyoperation.
• Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Grease
Coat the shank end of the bit beforehand with a small
amountofgrease(about0.5-1g).Thischucklubrica-
tion assures smooth action and longer service life.
Installing or removing bit
Cleantheshankendofthebitandapplygreasebefore
installing the bit.
1
2
►1. Shank end 2. Grease
Insert the bit into the tool. Turn the bit and push it in until
itengages.Afterinstallingthebit,alwaysmakesure
thatthebitissecurelyheldinplacebytryingtopullit
out.
1
►1. Bit
Toremovethebit,pullthechuckcoverdownalltheway
and pull the bit out.
1
2
►1. Bit 2. Chuck cover