User Manual

22 ENGLISH
OPTIONAL
ACCESSORIES
CAUTION: These accessories or attachments
are recommended for use with your Makita tool
 The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
󰀨
Vario-Power spray lance
Fig.42
Jet pressure can be adjusted by rotating the nozzle.
CAUTION: When adjusting the jet pressure,
do not rotate the nozzle while pulling it toward the
trigger gun.󰀨-
ger gun and cause a personal injury.
Foam nozzle

Fig.43
Detergent can be sprayed as foam.
Washing brush (long)
Fig.44
A nozzle equipped with a brush. Useful for washing out
dirt while scrubbing with brush.
Suction hose set
Fig.45
Replace the water hose with this set to supply water
from a tank or reservoir.
Rotating wash brush
Fig.46
Three brushes inside rotate slowly when ejecting the
jet. Suitable for cleaning light dirt on a exterior wall, car
body, bath tub, etc.
Lance extension
Fig.47
Pipes to extend the length of the trigger gun. Three
󰀨
of the pipes to be used.
Under body spray lance
Fig.48
An extra long spray lance with angled nozzle. Best for cleaning
hard-to-reach areas such as car under body and roof gutter.
CAUTION: Do not use the under body spray
lance with the lance extension.
Splash guard
Fig.49
Reduces splash back when cleaning corners with the
dirt blaster.
Swivel joint
Fig.50
Prevents the high-pressure hose from being twisted.
Connecting joint
Fig.51
A joint to connect with a nozzle from other model.
Some optional nozzles require the connecting joint
(optional accessory) to attach to the trigger gun. Attach
the connecting joint to the trigger gun in the same way
as the nozzle.
Fig.52: 1. Nozzle 2. Connecting joint 3. Trigger gun
NOTE: The connecting joint is needed when using
the nozzles included with another model, HW112 or
HW121.

Fig.53
For cleaning and unclogging plumbing and downpipes.
CAUTION: Pay particular attention to the
water jet when using the pipe cleaning hose.
Highly intense water jet is ejected backward. Only
trigger the water jet when the nozzle has been
inserted into the pipe to be cleaned at least up to
the red marking.
Extension high-pressure hose

Fig.54
Extension hose to connect the high pressure washer
body with the trigger gun.
Vario-Power Spray Nozzle and
Extension
Fig.55: 1. Vario-power spray nozzle 2. Extension
Jet pressure can be adjusted by rotating the nozzle.
WARNING: Install only the vario-power spray
nozzle to the extension. Do not connect the other
optional extensions to the original extension.
Using any attachments other than those recom-
mended by the manufacturer may cause a risk of
damage or injury to persons.
CAUTION: When adjusting the jet pressure,
do not rotate the nozzle while pulling it toward the
trigger gun.󰀨-
ger gun and cause a personal injury.