User Manual

6 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: DLW140
Wheel diameter 355 mm
Hole diameter 25.4 mm
Max. wheel thickness 3 mm
No load speed 3,800 min
-1
Rated voltage D.C. 36 V
Dimensions
(L x W x H)
With European type safety guard 537 mm x 290 mm x 640 mm
With safety guard other than
European type
537 mm x 280 mm x 640 mm
With center cap type safety guard 537 mm x 280 mm x 640 mm
Net weight
With European type safety guard 17.2 - 17.8 kg
With safety guard other than
European type
15.6 - 16.3 kg
With center cap type safety guard 15.4 - 16.0 kg
• Duetoourcontinuingprogramofresearchanddevelopment,thespecicationshereinaresubjecttochange
without notice.
• Specicationsmaydifferfromcountrytocountry.
• Theweightmaydifferdependingontheattachment(s),includingthebatterycartridge.Thelightestandheavi-
estcombination,accordingtoEPTA-Procedure01/2014,areshowninthetable.
• Theshapeandweightvarydependingonthespecicationswhichdiffercountrytocountry.
Applicable battery cartridge and charger
Battery cartridge BL1815N/BL1820/BL1820B/BL1830/BL1830B/BL1840/
BL1840B/BL1850/BL1850B/BL1860B
Charger DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
• Someofthebatterycartridgesandchargerslistedabovemaynotbeavailabledependingonyourregionof
residence.
WARNING: Only use the battery cartridges and chargers listed above.Useofanyotherbatterycartridges
andchargersmaycauseinjuryand/orre.
Intended use
The tool is intended for cutting in ferrous materials with
appropriateabrasivecut-offwheel.Followalllawsand
regulations regarding dust and work area health and
safety in your country.
Noise
ThetypicalA-weightednoiseleveldeterminedaccord-
ing to EN62841-3-10:
Sound pressure level (L
pA
):103dB(A)
Sound power level (L
WA
):115dB(A)
Uncertainty(K):3dB(A)
WARNING: Wear ear protection.
Vibration
Thevibrationtotalvalue(tri-axialvectorsum)deter-
mined according to EN62841-3-10:
Vibrationemission(a
h
):2.5m/s
2
Uncertainty(K):1.5m/s
2
NOTE: Thedeclaredvibrationemissionvaluehasbeen
measured in accordance with the standard test method
andmaybeusedforcomparingonetoolwithanother.
NOTE: Thedeclaredvibrationemissionvaluemay
alsobeusedinapreliminaryassessmentofexposure.
WARNING:Thevibrationemissionduringactual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING: Be sure to identify safety measures
toprotecttheoperatorthatarebasedonanestima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
TheECdeclarationofconformityisincludedasAnnexA
to this instruction manual.