Operation Manual

11
Charging with USB power supply port
(Fig. 9)
The maximum volume of the output power speaker will
decrease when your USB is charging.
The USB socket can provide max 1A5V of electrical
current.
Important:
Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
The charger may not supply power to some USB
devices.
When not using or after charging, remove the USB
cable and close the cover.
Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended for
charging lower voltage device. Always place the cover
onto the USB port when not charging the lower voltage
device.
Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
Do not connect this USB socket with your PC USB
port, as it is highly possible that it may cause
breakdown of the units.
MAINTENANCE
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Specifications:
Power Requirements
AC power adaptor DC12 V/1,200 mA, center pin
positive
Battery UM-3 (AA size) x 2 for back up
Cluster battery: 7.2 V - 10.8 V
Slide battery: 14.4 V - 18 V
Frequency coverage FM 87.50 - 108 MHz
(0.05 MHz/step)
AM (MW) 522 - 1,629 kHz
(9 kHz/step)
Bluetooth
®
Bluetooth
®
QD ID 58625
(The Bluetooth
®
word mark and
logos are registered trademarks
owned by Bluetooth SIG, Inc.)
Bluetooth
®
version 4.0
Bluetooth
®
profiles A2DP/SCMS-T
Transmission power Bluetooth
®
specification power
Class 2
Transmission range Max. 10 m (varies according to
usage conditions)
Supported codec SBC
Compatible Bluetooth
®
profile
A2DP
Circuit feature
Loudspeaker 3.5 inches 8 ohm x 2
Output Power 7.2 V: 0.5 W x 2
10.8 V:1.2 W x 2
14.4 V: 2.2 W x 2,
18 V: 3.5 W x 2
Input terminal 3.5 mm dia. (AUX IN1/AUX IN2)
Antenna system FM: soft bended rod antenna
AM: bar antenna
Dimension (W x H x D) in mm
282 x 294 x 163
Weight 4.3 kg (without battery)