User Manual

5
ENGLISH (Original instructions)
Explanation of general view
1-1. Button
1-2. Red indicator
1-3. Battery cartridge
2-1. Star marking
3-1. Indication lamp
4-1. Pointer
4-2. Stopper
4-3. Adjusting screw
4-4. Rubber spike
5-1. Lock lever
5-2. Angle guide
5-3. Knob
5-4. Scale
5-5. Pointer
5-6. Tighten
5-7. Loosen
6-1. Knob
6-2. Down
6-3. Up
6-4. Center of blade thickness
7-1. Fence
7-2. Angle scale
7-3. Lock lever
7-4. Tighten
7-5. Loosen
8-1. Lock lever
8-2. Pointer
8-3. Angle scale
8-4. Center of blade thickness
8-5. Blade cover
9-1. Lock lever
9-2. Pointer
9-3. Angle scale
9-4. Set plate
9-5. Thickness of set plate
9-6. Center of blade thickness
9-7. Blade cover
10-1. Set plate
11-1. Slide switch
12-1. Lock nut
12-2. Plate joiner blade
12-3. Blade cover
12-4. Inner flange
12-5. Clamp screw
12-6. Shaft lock
12-7. Loosen
12-8. Tighten
13-1. Dust bag
13-2. Fastener
13-3. Dust nozzle
28-1. Exhaust vent
28-2. Inhalation vent
29-1. Limit mark
30-1. Holder cap cover
30-2. Screwdriver
31-1. Brush holder cap
31-2. Screwdriver
SPECIFICATIONS
Model DPJ140 DPJ180
Type of blade Plate joiner
Max. grooving depth 20 mm
No load speed (min
-1
) 6,500
Overall length 351 mm
Net weight 3.0 kg
Rated voltage D.C. 14.4 V D.C. 18 V
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
ENE013-1
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN60745:
Model DPJ140
Sound pressure level (L
pA
) : 73 dB (A)
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Model DPJ180
Sound pressure level (L
pA
) : 74 dB (A)
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : cutting grooves in MDF
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.