Operators Manual
10 ENGLISH
NOTE: If the head of the pin nail still remains above
the workpiece even you hold the pin nail head,
the material may not be suitable for the pin nailer.
Continuing to use the pin nailer on such material may
resultinadamagetothedriverofthepinnailerand/
orpinnailerjamming.
Anti dry re mechanism
WARNING: Always make sure that your
ngers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before loading the pin nailer.
When the number of remaining pin nails in the maga-
zineare0-3pieces,theswitchtriggercannolongerbe
pulled.Atthistime,insertanewstripofpinnailsinthe
magazine and the switch trigger can be pulled again.
NOTE:Whenringadifferentlengthofpinnails
shortlyaftertheanti-dryringdevicehasactuated,
insert a new strip of pin nails into the magazine and
reawayallthepriorpinnailsthathaveremainedon
junkmaterial.
Checking remaining pin nails
You can check the amount of remaining pin nails
through the sight window.
Theredindicatormovestowardfasteningopeningwith
the amount of remaining pin nails become smaller.
1
2
►1.Sightwindow2. Indicator
Removing jammed pin nails
WARNING: Always make sure that the battery
cartridge is removed before removing jammed
pin nails.
Takeoutpinnailsthatremaininsidethemagazine.
Remove three screws with the hex wrench that are
securing the driver guide cover.
Takethejammednailsfromthenailguidegroovethat
has appeared.
Whenitisdifculttotakeoutthejammednails,further
remove two screws with the hex wrench that are secur-
ingthecontacttopcover.Thentakethemout.
1
2
3
►1. Driver guide cover 2.Screw3. Contact top cover
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
TomaintainproductSAFETYandRELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
beperformedbyMakitaAuthorizedorFactoryService
Centers, always using Makita replacement parts.