Operators Manual

8 ENGLISH
1. Remove the battery cartridge.
2. Pressthelockingleverandslidethesubmaga-
zine backward.
1
2
►1. Locking lever 2. Sub magazine
3. Load staples into the main magazine with their
feet facing up.
1
2
►1. Staples 2. Main magazine
4. After loading staples, push back the sub-maga-
zine in place until it clicks.
Toremovestaples,followtheinstallationproceduresin
reverse.
Hook
CAUTION: Do not hang the hook from the
waist belt. Dropping the stapler, which is caused by
the hook accidentally coming out of place, may cause
unintentionalringandresultinpersonalinjuries.
Thehookisconvenientfortemporarilyhangingthetool.
Thiscanbeinstalledoneithersideofthetool.
Toinstallthehook,insertitintoagrooveinthetool
housing on either side and then secure it with a screw.
Toremove,loosenthescrewandthentakeitout.
1
2
3
►1. Groove 2. Hook 3. Screw
OPERATION
Testing the safety system
WARNING: Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
1
2
3
4
►1.Trigger-lockbutton2. Switch trigger 3. Contact
element 4. Sub magazine
Testsafetysystemsforpossiblefaultbeforeoperation
as following.
1. Unloadthetoolwithstaplesandkeepthesub
magazine opened.
2. Install the battery cartridge.
3. Only pull the switch trigger without touching the
contact element against the material.
4. Only touch the contact element against the mate-
rial without pulling the switch trigger.
If the tool operates in the case of 3 and 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.