Operators Manual
9 ENGLISH
Driving staples
WARNING: Until driving staples completely,
always make sure that the contact element placed
rmly on the material.Unintentionalringmay
causepersonalinjuries.
1
2
3
4
►1. Switch trigger 2. Contact element 3. Front part
4. Rear part
You can operate the tool in either way of “single
sequentialactuation”or“contactactuation”.
Single sequential actuation:
Inthismode,youcandriveonestaplebyonesequen-
tial operation.
1. Placeatthecontactelementonthematerial.
2. Hold both of the front part and the rear part of the
toolrmlyagainstthematerial.
3. Pulltheswitchtriggerfullytodrivethestaples.
4. Releaseyourngerfromtheswitchtriggerbefore
move the contact element from the material.
Contact actuation:
In this mode, you can drive staples repetitively.
1. Pulltheswitchtrigger.
2. Withtheswitchtriggerpulled,placeatthecon-
tact element on the material to drive the staples.
3. Movethetooltothenextareaandplaceatthe
contact element on the material again.
NOTE:Thegrooveindicatesthepointthatstapleis
driven.
1
►1. Groove
When the head of driven staple remains above the
workpiece surface, drive the staple while holding the
staplerheadrmly.
Thematerialmaybeunsuitable,iftheheadofdriven
staple remains above the workpiece surface although
thestaplerheadisheldrmly.
NOTE:Usingthestaplercontinuouslywiththehead
of driven staples remaining above the surface of
material may cause damage to the driver of the sta-
plerandstaplerjammingetc.
Anti dry re mechanism
WARNING: When loading staples, always
make sure that the battery cartridge is removed
from the stapler.Unintentionalringmaycause
personalinjuriesandpropertydamage.
Thistoolisequippedwithanantidryremechanism.
When the number of remaining staples in the magazine
becomes 5 - 8 pcs., the switch trigger can no longer be
pulled. At this time, insert a new strip of staples in the
magazine.Theswitchtriggercanbepulledagain.
Checking remaining staples
1
2
3
►1. Sight window 2.Pusher3. Staples
Remaining staples can be checked through the sight
window.
Reload staples when no remaining staples can be seen
in the sight window.