operation manual

ManualsBrandsMakita ManualsMakita Cordless Screwdrivers & Cordless ScrewdriversDTD153Z

7 ENGLISH

For tool with shallow driver bit hole

A=12mm

B=9mm

Useonlythesetypeofdriver

bit. Follow the procedure

1. (Note) Bit-piece is not

necessary.

For tool with deep driver bit hole

A=17mm

B=14mm

Toinstallthesetypesofdriver

bits,followtheprocedure1.

A=12mm

B=9mm

Toinstallthesetypesofdriver

bits,followtheprocedure2.

(Note) Bit-piece is necessary

forinstallingthebit.

Procedure 1

For tool without one-touch type sleeve

►Fig.8: 1. Driver bit 2. Sleeve

Toinstallthedriverbit,pullthesleeveinthedirectionof

thearrowandinsertthedriverbitintothesleeveasfar

as it will go.

Thenreleasethesleevetosecurethedriverbit.

For tool with one-touch type sleeve

Toinstallthedriverbit,insertthedriverbitintothe

sleeveasfarasitwillgo.

Procedure 2

In addition to Procedure 1, insert the bit-piece into the

sleevewithitspointedendfacingin.

►Fig.9: 1. Driver bit 2. Bit-piece 3. Sleeve

Toremovethedriverbit,pullthesleeveinthedirection

ofthearrowandpullthedriverbitout.

NOTE:Ifthedriverbitisnotinserteddeepenough

into the sleeve, the sleeve will not return to its original

position and the driver bit will not be secured. In this

case, try re-inserting the bit according to the instruc-

tions above.

NOTE:Whenitisdifculttoinsertthedriverbit,pull

thesleeveandinsertitintothesleeveasfarasitwill

go.

NOTE:Afterinsertingthedriverbit,makesurethatit

isrmlysecured.Ifitcomesout,donotuseit.

Installing hook

►Fig.10: 1. Groove 2. Hook 3. Screw

Thehookisconvenientfortemporarilyhangingthetool.

Thiscanbeinstalledoneithersideofthetool.Toinstall

the hook, insert it into a groove in the tool housing on

eithersideandthensecureitwithascrew.Toremove,

loosen the screw and then take it out.

OPERATION

►Fig.11

Theproperfasteningtorquemaydifferdependingupon

thekindorsizeofthescrew/bolt,thematerialofthe

workpiecetobefastened,etc.Therelationbetweenfas-

teningtorqueandfasteningtimeisshowninthegures.

Proper fastening torque for standard bolt

140

N•m

(kgf•cm)

(1428)

120

(1224)

100

(1020)

(816)

(612)

(408)

(204)

M16

M10

M14

M12

(M16)

(M14)

(M12)

(M10)

(M8)

2.01.0

1. Fastening time (second) 2.Fasteningtorque

Proper fastening torque for high tensile bolt

200

(2040)

N•m

(kgf•cm)

180

(1836)

160

(1632)

140