Operation Manual

4 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: DTW284 DTW285
Fastening capacities Standard bolt M10 - M20
High tensile bolt M10 - M16
Square drive 12.7 mm
No load speed Hard impact mode 0 - 2,800 min
-1
Medium impact mode 0 - 2,100 min
-1
Soft impact mode 0 - 1,600 min
-1
Impacts per minute Hard impact mode 0 - 3,500 min
-1
Medium impact mode 0 - 2,600 min
-1
Soft impact mode 0 - 1,800 min
-1
Overall length 147 mm
Rated voltage D.C. 14.4 V D.C. 18 V
Battery cartridge BL1415, BL1415N BL1430, BL1430B,
BL1440, BL1450,
BL1460B
BL1815, BL1815N,
BL1820, BL1820B
BL1830, BL1830B,
BL1840, BL1840B,
BL1850, BL1850B,
BL1860B
Net weight 1.4 kg 1.6 kg 1.5 kg 1.7 kg
• Duetoourcontinuingprogramofresearchanddevelopment,thespecicationshereinaresubjecttochange
without notice.
• Specicationsandbatterycartridgemaydifferfromcountrytocountry.
• Weight,withbatterycartridge,accordingtoEPTA-Procedure01/2003
Intended use
Thetoolisintendedforfasteningboltsandnuts.
Noise
ThetypicalA-weightednoiseleveldeterminedaccord-
ingtoEN60745:
Sound pressure level (L
pA
):96dB(A)
Sound power level (L
WA
):107dB(A)
Uncertainty(K):3dB(A)
WARNING: Wear ear protection.
Vibration
Thevibrationtotalvalue(tri-axialvectorsum)deter-
minedaccordingtoEN60745:
Model DTW284
Workmode:impacttighteningoffastenersofthemaxi-
mum capacity of the tool
Vibration emission (a
h
):14.0m/s
2
Uncertainty(K):1.5m/s
2
Model DTW285
Workmode:impacttighteningoffastenersofthemaxi-
mum capacity of the tool
Vibration emission (a
h
):11.5m/s
2
Uncertainty(K):1.5m/s
2
NOTE:Thedeclaredvibrationemissionvaluehas
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE:Thedeclaredvibrationemissionvalue
may also be used in a preliminary assessment of
exposure.
WARNING:Thevibrationemissionduringactual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING: Be sure to identify safety measures
to protect the operator that are based on an estima-
tionofexposureintheactualconditionsofuse(taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
TheECdeclarationofconformityisincludedasAnnexA
to this instruction manual.