User Manual

9 ENGLISH
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
.
NOTE:Alllampsontheswitchpanelgooutwhenthetoolisturnedo󰀨tosavethebatterypower.Theimpactforce
gradecanbecheckedbypullingtheswitchtriggertotheextentthatthetooldoesnotoperate.
Changing the application mode
Thistoolemploysseveraleasy-to-useapplicationmodesfordrivingboltswithgoodcontrol.
Thetypeoftheapplicationmodechangeseverytimeyoupressthebutton
.
NOTE:
Youcanextendthetimetochangetheapplicationmodeapproximatelyoneminuteifyoupressthebutton or .
Application mode
(Assist type displayed on panel)
Feature Purpose
Bolt mode Clockwise
This mode helps to repeat screwdriving
continuouslywithequaltorque.Thismode
also helps to reduce the risk of breakage
of bolts/nuts due to overtightening.
Counterclockwise
This mode helps to prevent a bolt from
fallingo󰀨.Whenlooseningaboltwith
the tool driving in counterclockwise
rotation,thetoolautomaticallystops
or slows down after the bolt/nut gets
enough loosened.
NOTE:
The timing to stop the driving varies
depending on the type of the bolt/nut
and material to be driven. Make a test
driving before using this mode.
Clockwise
Preventing over tightening of bolts.
Counterclockwise
Loosening bolts.
Bolt mode (1)
Clockwise
Thetoolstopsautomaticallyassoonas
it has started impact blows.
Counterclockwise
The impact force is 4. The tool stops
automaticallyassoonasithasloos-
ened the bolt/nut.
–
Bolt mode (2)
Clockwise
Thetoolstopsautomaticallyapprox-
imately0.5secondlaterfromthe
moment that the tool has started impact
blows.
Counterclockwise
The impact force is 4. The tool stops
automaticallyassoonasithasloos-
ened the bolt/nut.
–