Instruction Manual

Table Of Contents

Using the Wall Scanner

Selecting a scan mode

Use the right and left buttons ( ) to select either the “Single Detection” or

“Multi Detection” mode, and press the apply button (

1. Battery change mark

2. Signaling sound on/off

3. Scan mode

1. “Single Detection” mode

This mode gives you the basic functionality. Move the scanner side to side

to detect any buried objects after applying the scanner's sensor surface

to the surface from which to detect any buried objects. Scan results are

shown in the scanner's display so that you can see the location and depth

data of the buried object.

When there is a buried object under the sensor, a burial detection mark

blinks or a beep sounds to let you know of it.

2. “Multi Detection” mode

This mode performs three lines of buried object scan continuously. The

scan results for the three lines are shown in the scanner's display. This

mode is useful to scan for buried objects which are not necessarily

straight, such as in-concrete power distribution resin tubes.

(See “Searching for wiring resin pipes in concrete” in page 41.)