Use and Care Manual
3
  (5) Notwithstanding the provisions of Subsection (4) above, warranty services or repairs must be provided at all 
manufacturer distribution centers that are franchised to service the subject engines.
  (6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in 
fact defective, provided that such diagnostic work is performed at a warranty station.
  (7) The manufacturer is liable for damages to other engine components proximately caused by a failure under 
warranty of any warranted part.
  (8) Throughout the emissions warranty period dened in Subsection (b)(2), the manufacturer must maintain a 
supply of warranted parts sufcient to meet the expected demand for such parts.
  (9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be 
provided without charge to the owner. Such use will not reduce the warranty obligations of the manufacturer.
  (10) Add-on or modied parts that are not exempted by the Air Resources Board may not be used. The use of any 
non-exempted add-on or modied parts will be grounds for disallowing a warranty claim. The manufacturer will not 
be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modied part.
  (11) The manufacturer issuing the warranty shall provide any documents that describe that manufacturer's war
-
ranty procedures or policies within ve working days of request by the Air Resources Board.
(d) Emission Warranty Parts List
(1)  Fuel Metering System
    (I)  Carburetor
    (II)  Fuel lter, if applicable
    (III)  Choke (Cold start enrichment system)
    (IV)  Fuel Tank
(2) 
Air Induction System
    (I)  Intake manifold.
    (II)  Air lter.
(3) 
Ignition System
    (I)  Spark Plug
    (II)  Ignition coil
    (III)  Flywheel Magneto
(4) 
Exhaust Gas Recirculation (EGR) System (if applicable)
    (I)  EGR chamber   
(5) 
Catalyst, if applicable
    (I)  Catalytic converter, if applicable
(6) 
Miscellaneous Items Used in Above Systems
    (I)  Hoses, belts, connectors, sealing gaskets, clamps, fasteners
    (II)  Fuel cap
MAKITA  will  furnish  with  each  new  engine  written  instructions  for  the  maintenance  and  use  of  the  engine  by  the  
owner.










