Troubleshooting Guide

17
Screw the disassembly mandrel
(944.500.880) onto the threaded end of the
shaft.
Do not screw the mandrel all the way down.
Leave about 2 mm between the mandrel and
the flywheel.
Hold the machine in one hand or place on a
soft surface, and knock the flywheel loose with
a tap on the mandrel.
Removing the ignition armature
Unscrew 2 screws on ignition armature 1.
Unscrew ignition cable screw 2.
Remove armature 1 and wire.
1
2
Removing the flywheel
Block the piston. To do this, see 04 CLUTCH.
Loosen the nut in the direction of the arrow
and remove it along with the washer.
07
IGNITION S
YSTEM