Use and Care Manual
23
ENGLISH
Fault location
Fault System Observation Cause
Engine not starting or
with difculty
Ignition system Ignition sparks. Fault in fuel supply or
compression system,
mechanical defect.
No ignition sparks. STOP-switch operated,
wiring fault or short
circuit, spark plug or
connector defective,
ignition module faulty.
Fuel supply Fuel tank lled. Incorrect choke posi-
tion, carburetor defec-
tive, fuel supply line
bent or blocked, fuel
dirty.
Compression No compression when
pulled over.
Cylinder bottom gasket
defective, crankshaft
seals damaged, cyl-
inder or piston rings
defective or improper
sealing of spark plug.
Mechanical fault Starter not engaging. Broken starter spring,
broken parts inside of
the engine.
Warm start problems - Tank lled. Ignition
sparks.
Carburetor contami-
nated, have it cleaned.
Engine starts but dies Fuel supply Tank lled. Incorrect idling adjust-
ment, carburetor
contaminated.
Fuel tank vent defec-
tive, fuel supply line
interrupted, cable or
STOP-switch faulty.
Insufcient
performance
Several systems may
simultaneously be
affected
Engine idling poor. Air lter contaminated,
carburetor contami-
nated, mufer clogged,
exhaust duct in the
cylinder clogged.
Interval of inspection and maintenance
- Before
operation
After
fuelling
Daily
(10h)
50h 200h
600h or
2 years
whichever
earlier
Before
storage
Engine
oil
Inspect /
rell
- - - - - -
Replace - - -
(Note1)
- - -
Tightening
parts
(bolt, nut)
Inspect - - - - - -