Service manual

3. Rod slide plate, Pinion gear, Felt
Loosen 2 screws (M3 x 5) and remove rod slide plate fixed under lower case.
Then remove pinion gear from upper case. If it is hard to remove, tap pinion with plastic hammer.
Then remove felt.
4. Rod
Remove rod on lower-blade side.
<Caution>
Before removing rod, apply a small amount of grease to needles and turn rod several times
so that they will
not separate.
Keep in memory rod mounting direction.
Apply grease to crank and lower-blade rod shift and mount rod.
5. Lower/Upper blade
Loosen
3 blade-slide screws and remove lower blade.
<Caution>
Be careful not to miss blade slide washer.
Then remove upper blade.
6. Crank gear, Crank
Remove crank gear and crank from upper case.
If it is hard to remove, tap case with plastic hammer.
Then loosen screws
(M5 x 10) fixing crank gear and crank and remove crank.
<Caution>
Apply grease to upper case in proper amount.
Apply grease to crank gear and crank in proper quantity and mount them in upper.
7. Retainer plate, Grease nipple
Loosen flange nut and
2 screws (M5 x 16) and remove retainer plate. Then remove grease nipple.