Use and Care Manual

25
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Operator’s manual. All such work must be
carried out by a MAKITA service center.
Replacing/cleaning the spark arrester screen
CAUTION:
Do not use sharp or pointed objects for screen cleaning.
Damaged or misformed screen wires may result.
The spark arrester screen should be checked and cleaned
regularly.
Let cool the engine down for sure!
Unscrew and remove screw (1). Remove the spark
arrester screen (2).
Cleaning or replacing the spark arrester screen.
Reassembly the spark arrester screen and tighten the screw.
1
2
General Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Cutting disc Inspect regularly for damage and wear. 8
Clutch Have inspected at a service center.
Protection hood Clean 21
Before each start Cutting disc Inspect for damage and make sure the cutting wheel is 8
right for the job
Protective hood Adjust position 18
Combination switch, Functional check
Safety locking button, Functional check
Throttle lever Functional check 18
Tank cap Check for tightness
Every day Idle speed Check (cutting disc must not turn on idle) 19
Every week Starter housing Clean to ensure proper air cooling 14
Starter cable Check for damage 23
V-belt Inspect for damage and wear 20
Spark plug Check and replace if necessary 22
Mufer Check tightness of mounting 14
Spark arrester screen Clean or replace if necessary 26
Screws and nuts Check their condition and that they are rmly secured.
Monthly Air lter insert Check the air lter insert, clean as needed,
replace after 500 operating hours 21
Every 3 months Suction head Replace 22
Fuel tank Clean
Annually Entire Power Cut Check at an authorized service center
Storage Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Cutting disc Remove and clean 15
Fuel tank Empty and clean
Carburetor Run empty
Page