User Manual

CAUTION: Before doing any work on the equipment, always stop the engine and pull the spark plug connector off the spark plug.

Always wear protective gloves!

CAUTION: Start the engine only after having assembled it completely.

MOUNTING OF HANDLE

For loop handle models

– Fix a barrier (1) to the left side of the machine together with the handle for

operator protection.

– Make sure that the grip/barrier assembly is tted between the spacer and the

arrow mark (2).

WARNING: Do not remove or shrink the spacer (3). The spacer keeps a

certain distance between both hands. Setting the grip/barrier

assembly close to the other grip beyond the length of the

spacer may cause loss of control and serious personal injury.

NOTE:

– In some countries the spacer is not included. In that case t the grip/barrier

assembly between arrow marks.

(1)

(2)

(3)

(2)

(1)

For bike handle models

– Place the handle with the throttle lever on the handle holder on the right side (to

be held by the right hand) and the other on the left side.

– Fit the handle edge to the handle holder groove, and provisionally x the upper

side (1) of the handle holder by four bolts M5 x 25 (2).

– Adjust the handle to an angle easy to manipulate, and tighten the bolt (2)

uniformly on the right and left sides.

EM3400U

EM3400L