Manualshelf

Use and Care Manual

ManualsBrandsMakita ManualsOutdoor Power Equipment25.4 cc MM4 4-Stroke Couple Shaft Power Head and 42 in. Shaft Extension Attachment and 10 in. Pole Saw Attachment
12345678910
9
CAUTION: Before doing any work on the Multi Function Power Head, always
stop the engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Multi Function Power Head only after having assembled it
completely.
Assembly
- Loosen lever.
- Align the attachment’s pin with the joint’s groove and insert pin.
- Insert attachment up to the arrow position of attachment.
And, check to see that button has risen.
- Tighten lever.
(See diagram on right for guideline.)
MOUNTING OF HANDLE
MOUNTING ATTACHMENT
Engine
Joint
CAUTION: Before doing any work on the Multi Function Power Head, always
stop the engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Multi Function Power Head only after having assembled it
completely.
Assembling loop handle
- Securely t the barrier and grip onto the shaft pipe with two screws and
clamps. At this time, put the barrier on the left side of the machine as
illustrated.
- Make sure that the grip/barrier assembly is located between the spacer and
the arrow mark. Do not remove or shrink the spacer.
- Once assembled, do not remove the barrier.
CAUTION: Never install the grip on the label or joint.
Note: In some countries, the barrier and arrow mark are not provided with the
tool.
Arrow mark