ENGLISH (Original instructions) INSTRUCTION MANUAL Drywall Screwdriver FS4000 FS4200 FS4300 FS4300A FS6300 FS6300A FS6300R 009959 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS FS4000 FS4200 FS4300/ FS4300A Self drilling screw 6 mm 6 mm 6 mm - - Drywall screw 5 mm 5 mm 5 mm 4 mm 4 mm No load speed (min-1) 0 - 4,000 0 - 4,000 0 - 4,000 0 - 6,000 0 - 6,000 Overall length 269 mm 269 mm 279 mm 279 mm 279 mm Net weight 1.3 kg 1.4 kg 1.4 kg 1.4 kg 1.
GEA005-2 under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. 11. Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. 12. Prevent unintentional starting.
FUNCTIONAL DESCRIPTION power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 23. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed.
Switch action Reversing switch action 1. Switch trigger 2. Lock button 1. Reversing switch lever 1 A 1 2 B 009961 009962 CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop.
Grasp the bit with a pair of pliers and pull the bit out of the magnetic bit holder. Sometimes, it helps to wiggle the bit with the pliers as you pull. To install the bit, push it firmly into the magnetic bit holder. Then install the locator by pushing it firmly back onto the gear housing. 1. Locator 2. Bit 3. Gear housing 4. Magnetic bit holder 1 004180 Removing removable cord adapter 1.
ACCESSORIES The locator can be temporarily held on the locator holder during replacing bit or using without locator. To hold the locator, position the trapezoidal holes of the locator on the swells of the locator holder and push it in. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
Makita Corporation Anjo, Aichi, Japan 884894A225 8
