Instructions
13 ENGLISH
Releasing protection lock
When the protection system works repeatedly, the tool
is locked.
In this situation, the tool does not start even if turning
Shaft lock
installing or removing accessories.
Fig.3: 1. Shaft lock
NOTICE: Never actuate the shaft lock when the
spindle is moving.
Switch action
CAUTION: Before installing the battery car-
tridge into the tool, always check to see that the
slide switch actuates properly and returns to the
"OFF" position when the rear of the slide switch
is depressed.
CAUTION: Switch can be locked in "ON" posi-
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
To start the tool, slide the slide switch toward the “I
For continuous operation, press the front of the slide
switch to lock it.
To stop the tool, press the rear of the slide switch, then
Fig.4: 1. Slide switch
Accidental re-start preventive
function
not start.
position.
Electronic torque control function
The tool electronically detects situations where the
further rotation of the spindle (it does not prevent
cause of sudden drop in the rotation speed, and then
turn the tool on.
Soft start feature
Soft start feature reduces starting reaction.
ASSEMBLY
CAUTION: Always be sure that the tool is
before adjusting or checking function on the tool.
Installing side grip (handle)
CAUTION: Always be sure that the side grip is
installed securely before operation.
Screw the side grip securely on the position of the tool
Fig.5
Installing or removing wheel guard
WARNING: When using a depressed center
the closed side of the guard always points toward
the operator.
WARNING:
diamond wheel, be sure to use only the special wheel
While pushing the lock lever, mount the wheel guard
with the protrusions on the wheel guard aligned with the
guard until the wheel guard is locked in place.
Fig.6: 1. Lock lever 2. Notch 3.
To remove wheel guard, follow the installation proce-
dure in reverse.
Adjusting angle of wheel guard
WARNING: Make sure that the wheel guard is
on the wheel guard.
rotating the wheel guard with pushing it down while
protected.
Fig.7: 1. Wheel guard 2.