Instructions
15 ENGLISH
Fig.18: 1. Lock nut 2.
3.
4. Inner
When installing the diamond wheel:
Fig.19: 1. Lock nut 2. Diamond wheel (Thinner than
3. Diamond wheel (4 mm
4.
model
Fig.20: 1. Lock nut 2.
3.
4. Inner
When installing the diamond wheel:
Fig.21: 1. Lock nut 2. Diamond wheel (Thinner than
3. Diamond wheel (4 mm
4.
Installing wire cup brush
Optional accessory
CAUTION: Do not use brush that is damaged,
or which is out of balance.
Fig.22: 1.
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire cup
Installing wire wheel brush
Optional accessory
CAUTION: Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
CAUTION: ALWAYS use guard with wire
inside guard. Wheel can shatter during use and
Fig.23: 1.
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire wheel
OPERATION
WARNING: It should never be necessary to
force the tool. The weight of the tool applies ade-
WARNING: ALWAYS replace wheel if tool is
dropped while grinding.
WARNING: NEVER bang or hit grinding disc
or wheel onto work.
WARNING: Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc. This can cause loss of control and
WARNING: NEVER use tool with wood cutting
blades and other saw blades.
CAUTION: Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION: Always wear safety goggles or a
face shield during operation.
CAUTION:
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
one hand on housing and the other on the side
grip (handle).
Grinding and sanding operation
Fig.24
Turn the tool on and then apply the wheel or disc to the
workpiece.
In general, keep the edge of the wheel or disc at an
work the grinder in forward direction or it may cut into