User Manual

5
ENGLISH (Original instructions)
Explanation of general view
1Shaft lock
2 Slide switch
3 Wheel guard
4 Bearing box
5Screw
6 Lever
7 Lock nut
8 Depressed center wheel
9 Inner flange
10 Lock nut wrench
11 Ezynut
12 Abrasive wheel
13 Spindle
14 Arrow
15 Notch
16 Flex wheel
17 Plastic pad
18 Sanding lock nut
19 Abrasive disc
20 Rubber pad
21 Marking A
22 Marking B
23 Marking C
24 Marking D
25 Abrasive cut-off wheel/diamond
wheel
26 Wheel guard for abrasive cut-off
wheel/diamond wheel
27 Wire cup brush
28 Wire wheel brush
29 Exhaust vent
30 Inhalation vent
SPECIFICATIONS
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE048-1
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
GEA010-1
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
GEB033-7
GRINDER SAFETY WARNINGS
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
1. This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool. Read
all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
2. Operations such as polishing are not recom-
mended to be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
3. Do not use accessories which are not specifi-
cally designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
4. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
5. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controlled.
Model GA4040 GA4540 GA4541 GA5040 GA5041 GA6040
Wheel diameter 100 mm (4") 115 mm (4-1/2") 125 mm (5") 150 mm (6")
Max. wheel thickness 6.4 mm
Spindle thread M10 M14 M14 M14
Rated speed (n) /
No load speed (n
0
)
11,000 min
–1
11,000 min
–1
11,000 min
–1
9,000 min
–1
Overall length 303 mm 303 mm 325 mm 303 mm 325 mm 303 mm
Net weight 2.3 kg 2.4 kg 2.6 kg 2.4 kg 2.6 kg 2.5 kg
Safety class /II