Use and Care Manual

12 ENGLISH
Installing abrasive cut-o󰀨 / diamond
wheel
Optional accessory
WARNING: When using an abrasive cut-o󰀨
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-o󰀨 wheels.
WARNING: NEVER use cut-o󰀨 wheel for side
grinding.
1
2
4
3
► 1. Lock nut 2. Abrasive cut-o󰀨 wheel / diamond
wheel 3. Inner ange 4. Wheel guard for abrasive
cut-o󰀨 wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner ange varies by wheel type and thickness.
Refer to the following gures.
When installing the abrasive cut-o󰀨 wheel:
11
44
23
► 1. Lock nut 2. Abrasive cut-o󰀨 wheel (Thinner than 4
mm (5/32")) 3. Abrasive cut-o󰀨 wheel (4 mm (5/32")
or thicker) 4. Inner ange
When installing the diamond wheel:
11
44
23
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32″)) 3. Diamond wheel (4 mm (5/32″) or thicker)
4. Inner ange
Installing wire cup brush
Optional accessory
CAUTION: Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
1
► 1. Wire cup brush
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench.