Use and Care Manual

9 ENGLISH
Switch action
Turning cleaner on
1. Turn the stand-by switch in the "I" (ON) or "AUTO"
(ON) position to have the cleaner ready in
stand-by mode.
2. Press the power button.
To switch back to stand-by mode, press the power
button again.
Turning cleaner o󰀨
Perform one of the following steps.
• Press the power button to set the cleaner back in
stand-by mode.
• Turn the stand-by switch in the "O" (OFF) position.
Adjusting suction power
The suction power can be adjusted according to your
work needs.
• Turn the suction force adjusting knob to the left to
reduce the suction power.
• Turn the suction force adjusting knob to the right
to increase the suction power.
1
2
3
Fig.6
► 1. Stand-by switch 2. Suction force adjusting knob
3. Power button
NOTICE: Always set the stand-by switch to the "O"
side when not using the cleaner for long time. The
cleaner consumes power during stand-by state.
Auto-suction stop during wet
suction operation
WARNING: Do not pick up foam or soapy
liquid. It can cause foam to come out of air exit.
Continuous use under such conditions may cause an
electric shock and breakage of the cleaner.
The cleaner has a mechanism that prevents water from
immersing into the motor when picking up more than a
certain amount of water.
When the tank is full with liquid, the cleaner stops auto-
matically. Switch o󰀨 the cleaner and empty the tank.
Filter cleaning system
This appliance has lter cleaning system. During the
use of the appliance, lter cleaning system dusts the
lters automatically to prevent the suction force lower-
ing because of clogging of lters.
If the appliance sucks up the large quantity of dust all at
once, suction force may decrease. In that case, manual
lter cleaning is recommended.
1. Switch o󰀨 the appliance.
2. Set the suction power to maximum, and then close
the suction hose opening with your palm.
3. Switch on the appliance and operate for approx-
imately 15 seconds with the suction hose opening
closed.
1
Fig.7
► 1. Suction hose opening
NOTE: Air volume may change while the lter
cleaning system is being activated but it is not
malfunctioned.
Water drain
When the tank is full with liquid, switch o󰀨 the cleaner
and open the water drain cap to empty the tank.
1
Fig.8
► 1. Water drain cap